Page 1 of 1
Posted: Sun Feb 17, 2008 3:40 pm
by Bobby Spray
Due to site restrictions I need a 68mm low level P trap. I tried to make one with Marley rainwater pvc fitting but I am struggling to make it water tight. I used Marley PVC cement with no joy. Would denso tape help? failing that, is something similar available commercially?
Posted: Sun Feb 17, 2008 9:45 pm
by seanandruby
Geberit Terrain liquid weld solvent cement.
Geberit ltd .
Aylesford Kent me207pj.
TEL.01622717811.
Hope this is of use to you its for the 40 / 50ml
pvc fittings, should do for you.
Posted: Mon Feb 18, 2008 6:36 pm
by flowjoe
Nothing wrong with a bit of Denso Bobby, if its out of site and you are sure that the joints have enough solvent in them to hold then go for it.
You could always try FWB at Keighly they do more industrial pipework in all kinds of sizes, they may even have a push fit system you can use.
What is it for ? ??? what are you putting a trap in for
Posted: Tue Feb 19, 2008 10:51 am
by Bobby Spray
It's to connect a linear drain to a 110m surface water drain. The 110mm drain lies very close to the building and on a concrete float which means resticted acess to put a full size 110mm ptrap in place. It will b e underground so denso might do.