Wher can i buy one of these - 68mm low level p trap

Foul and surface water, private drains and public sewers, land drains and soakaways, filter drains and any other ways of getting rid of water.
Post Reply
Bobby Spray
Posts: 17
Joined: Fri Dec 28, 2007 4:45 pm
Location: Yorkshire

Post: # 25972Post Bobby Spray

Due to site restrictions I need a 68mm low level P trap. I tried to make one with Marley rainwater pvc fitting but I am struggling to make it water tight. I used Marley PVC cement with no joy. Would denso tape help? failing that, is something similar available commercially?

Image
Top
seanandruby
Site Admin
Posts: 4713
Joined: Mon Jun 26, 2006 11:01 am
Location: eastbourne

Post: # 25974Post seanandruby

Geberit Terrain liquid weld solvent cement.
Geberit ltd .
Aylesford Kent me207pj.
TEL.01622717811.
Hope this is of use to you its for the 40 / 50ml
pvc fittings, should do for you.
sean
Top
flowjoe
Posts: 1136
Joined: Sun May 08, 2005 9:25 am
Location: North West

Post: # 25984Post flowjoe

Nothing wrong with a bit of Denso Bobby, if its out of site and you are sure that the joints have enough solvent in them to hold then go for it.

You could always try FWB at Keighly they do more industrial pipework in all kinds of sizes, they may even have a push fit system you can use.

What is it for ? ??? what are you putting a trap in for
http://draindomain.com

Many paths can lead to riches, few in sunlight, some in ditches
Top
Bobby Spray
Posts: 17
Joined: Fri Dec 28, 2007 4:45 pm
Location: Yorkshire

Post: # 25998Post Bobby Spray

It's to connect a linear drain to a 110m surface water drain. The 110mm drain lies very close to the building and on a concrete float which means resticted acess to put a full size 110mm ptrap in place. It will b e underground so denso might do.
Top
Post Reply

Return to “Drainage”