The Brew Cabin

Posted: **Fri Jul 07, 2017 8:45 pm**

Almost finished laying a brett textured patio. All butted up.

Was going to brush in kiln dried sand but I was wondering if I could use easy joint so it could be jetwashed without blasting out the sand.

Would the easy joint get into the small gaps here and there you reckon?

Posted: **Sun Jul 09, 2017 6:58 am**

The only product to use with gaps so small is kiln dried sand as easy joint needs a minimum gap of 3mm ... other resin based jointing products need more

Posted: **Sun Jul 09, 2017 6:30 pm**

The GftK 815 will work in 3mm joints.....and it laughs at pressure washers!

The Brew Cabin

Using easy joint instead of kiln dried sand