Page 1 of 1
Posted: Thu May 07, 2009 2:15 pm
by sometimeshandy
I have a limestone patio with a 7 inch step down on the outside. the top outside edges were saw cut and are sharp. I was wondering if I could use a disk grinder to round these edges down or if it would just make a mess. thanx much.
Posted: Thu May 07, 2009 2:22 pm
by Tony McC
You could, but you should practice on a few offcuts first, as getting an even bullnose is not as easy as it may seem
Posted: Thu May 07, 2009 7:00 pm
by DNgroundworks
I saw a mason doing somthing similar the other day - he was using like a disc/cup diamond tipped attachment on a 4" grinder, He made it look easy!
Posted: Fri May 08, 2009 4:50 am
by seanandruby
This has been raised before. I think there is some kind of router out there to bevel them.
Posted: Fri May 08, 2009 10:22 am
by bodgeitandscarper
Could anyone give me some info on this stone router?
Posted: Fri May 08, 2009 6:47 pm
by henpecked
Its called a diamond router Dont know if Im allowed but heres a fleabay link>
Diamond Router
Posted: Sat May 09, 2009 1:47 pm
by sometimeshandy
thanx for the info everyone
Posted: Sat May 09, 2009 4:27 pm
by Tony McC
You can get one from Combined Masonry Supplies (CMS) in Bradford or Harbro International in Darlington.