The Brew Cabin

Posted: **Wed Jun 20, 2007 4:27 pm**

I am a complete novice to this. I have read the website advice. The following is what i think I should do. Lay a sub bed of 100mm hardcore and 100mm of bedding layer and lay flags on this. The bedding layer should be a mixture of sand and mortar (not building sand). In laying the flays can i have them join one another or should i leave a gap of say 3mm for pointing

Thanks for any advice.

Posted: **Wed Jun 20, 2007 10:02 pm**

Your bedding layer should be be between 35 to 50mm, no more. Indian flags are riven so cant be butt jointed. A 10mm pointing gap would be more appropriate.

Posted: **Wed Jun 20, 2007 10:25 pm**

I have read the website advice

no ,i dont think you have read the website advice, have you??
try reading it again and paying attention this time
LLL :;):

The Brew Cabin

Laying indian sandstone flags - Help