Posted: Sun Mar 07, 2010 4:03 pm
broken
The Brew Cabin
Paving, Drainage and Hard-landscaping in Britain and Ireland
https://ext.pavingexpert.com/brewcabin/
Manhole ring lifting pins
https://ext.pavingexpert.com/brewcabin/viewtopic.php?t=13831
Page 1 of 2
Posted: Sun Mar 07, 2010 4:06 pm
Photo is broken...
Posted: Mon Mar 08, 2010 8:47 pm
can,t see photo, so am assuming they are your own. How long have yoi had them and how did they break? Did you inform the hse? Time and time again i see guys in the hole with a ring swinging above them and pins in the wrong way round. I've seen them shake lose being wrong way whilst tracking along on 360. They break so easy, so do bones.
Posted: Mon Mar 08, 2010 9:06 pm
did you post a photo or just post broken haha
we have a few sets ones you push through and then slide a washer and split pin or ones that slide through then the end cranks over and slides down to make a T shape.
sean by pins in the wrong way round what you mean, the rings outside the manhole ring?
we have these
Edited By GB_Groundworks on 1268082684
we have a few sets ones you push through and then slide a washer and split pin or ones that slide through then the end cranks over and slides down to make a T shape.
sean by pins in the wrong way round what you mean, the rings outside the manhole ring?
we have these
Edited By GB_Groundworks on 1268082684
Posted: Mon Mar 08, 2010 9:43 pm
this lifter is what i use all the time they are german got them from ebay £80 just push them on a ring equi-distant around the ring
MSH
MSH
Posted: Mon Mar 08, 2010 9:46 pm
the heaver the ring the stronger the grip , no pins to lose chains are fixed to them tested to 2.5 ton on the chain, MSH
Posted: Mon Mar 08, 2010 10:09 pm
Nice, I like them.
We have got the ones with the eyes and a threaded section and nuts. Fiddly, but don't often lift Milton rings in these days.
We have got the ones with the eyes and a threaded section and nuts. Fiddly, but don't often lift Milton rings in these days.
Posted: Tue Mar 09, 2010 7:31 pm
Internal dropshaft MSH ?
Posted: Tue Mar 09, 2010 7:39 pm
you got it flojoe, was a crap job, 4 water services ontop off the clay 6" pipe ,angle all wrong client did not what to pay the proper price , as 4 waters had to be cut and jointed total 8 times no one knew they was there MSH
Posted: Tue Mar 09, 2010 7:40 pm
ground water was at invert leval, MSH
Posted: Tue Mar 09, 2010 8:55 pm
yes the rings should be outside. Yes i know before you say it, 'if you lift two rings that way they will tip and you'll smash one.' But you are'nt supposed to lift two.
Posted: Tue Mar 09, 2010 10:09 pm
i really am confused now
LLL
LLL
Posted: Wed Mar 10, 2010 6:58 am
The pins are the ones on the right hand side of Giles picture. There not broken there New. Just wanted to see if any1 was interested in purchasing them.
Posted: Wed Mar 10, 2010 9:44 pm
how much irish? MSH
Posted: Thu Mar 11, 2010 8:58 pm
just pin money :laugh:msh paving wrote:how much irish? MSH