The Brew Cabin

Posted: **Mon Nov 23, 2015 10:49 am**

Hi all,

Please could you advise on the best way to install a concrete edging such as the one below between the pavement and my driveway which will be block paved.

Concrete edging

I don't understand how I will be able to properly haunch the edging while installing it flush against the pavement's edge. Any advice on how you achieve this would be appreciated. Thanks.

Posted: **Mon Nov 23, 2015 10:55 am**

Leave the concrete low at the front and haunch the back well. If there is a slight gap fill it with a strongish mix of sharp sand and cement, you may have to hydro fill it slightly to send the mix down the gap if not to wide.

The Brew Cabin

Concrete edging between drive and pavement