Page 1 of 1
Posted: Fri Jun 09, 2017 8:37 pm
by Rawfella
Should I allow kerb repair mortar/resin to be used on newly laid kerbs Onsite, being pressured into thinking it'll be fine. Anyone used the aco kerb repair resin?
Posted: Fri Jun 09, 2017 10:54 pm
by seanandruby
Yes use it, it's a lot better than breaking out kerbs in the remedial stage which is very time consuming and expensive. Mark your kerbs so you remember which ones to head for becsuse it goes off quick. Strong and will stay done if done to instructions. Have used similar stuff, epoxy, to repair spigots and collers on concrete pipes before pushing them home.
Posted: Sat Jun 10, 2017 6:21 pm
by Tony McC
Although these epoxy mortar patch repairs never look good, they are widely acceptred and, as Sean says, it's hard to justify ripping out whole kerbs because of some scratch or spalling on the face.
The two exceptions would be any kerb that is cracked right through - repair mortar won't fix a crack - and spalling caused by laying kerbs butt-tight against their neighbours. Forcing a contracxtor to replace such damaged kerbs is the only way to teach them to lay close-jointed and not butt-jointed.
Edited By Tony McC on 1497115392