Page 1 of 1
Posted: Wed Apr 19, 2017 2:52 pm
by Gooty
Marshall website says 1:2:4 (Cement:Sand:Aggregate), and others say 1:3:6.
My question is what type of Aggregate and from where?
I've got the cement and sharp sand from wickes but they don't appear to have 6-10mm gravel.
Posted: Wed Apr 19, 2017 4:54 pm
by Tony McC
Kerbs for what purpose?
1:3:6 (C7.5 or GEN 0) is the usual for road kerbs, and it's more than ample for driveway/patio kerbs.
Much more on concrete mixes here....
Designated Concrete Mixes
...and on a mixed on-site C7.5.....
Bedding Concrete
Try shopping around: most builders' merchants will have a 6-10mm gravel. It's a reasonably common product.
Posted: Wed Apr 19, 2017 9:28 pm
by Gooty
My new drive butts on to a side road (private).
The top of the kerb between the two is level with both but is smashed and worn.
In replacing with new 125x150 bull nose
Posted: Thu Apr 20, 2017 6:35 am
by jwill
If wickes is your only option sure they would stock a 10mm ballast
Posted: Thu Apr 20, 2017 7:13 am
by Gooty
Wickes have 10mm pea shingle.
Is this the correct gravel?
Posted: Thu Apr 20, 2017 7:24 am
by seanandruby
You want all in ballast. That is your stone gravel and stone already mixed. If you buy shingle on it's own you will need to also buy sharp sand. I'm not sure which option comes out cheaper though
Posted: Fri Apr 21, 2017 10:11 am
by Tony McC
Ballast is OK for small, non-critical jobs, but because it's a get-what-you're-given mix of sandy bits and stony bits, there's no real control over the ratio of fine to coarse aggregate, so you get a highly variable concrete.
Those of us lucky enough to live in parts of the nation with good aggregate supplies, never use all-in ballast. It seems to be restricted to the agg-poor SE of Eng-er-land, but, due to the spread of national DIY sheds, it does occasionally make an appearance beyond its natural home.
As long as they don't start distributing that god-awful hoggin stuff - that should never be allowed out of the SE!