Posted: Sat Oct 13, 2007 5:08 pm
I'm looking for ideas on materials to surface and waterproof a concrete roof deck to be suitable for a car standing but good looking too.
The deck is precast conc. slabs with a 45mm screed over.
The snag is that it needs to be a thinish layer as there is garage off of the deck. Currently it has an inside floor level the same as the outside deck level so anything I add for waterproofing and paving needs to ramp down to taper down to the inside floor level.
First thoughts were asphalt with a promenade tile or a clay tile. Or perhaps a resin something or other could waterproof and surface in one go?
I know this is an odd one. Basically its a house on a steep hill. Road is at top with a drive going into an elevated garage. Under the drive and garage are areas being converted into the house.
Ideas much appreciated.
Pete
The deck is precast conc. slabs with a 45mm screed over.
The snag is that it needs to be a thinish layer as there is garage off of the deck. Currently it has an inside floor level the same as the outside deck level so anything I add for waterproofing and paving needs to ramp down to taper down to the inside floor level.
First thoughts were asphalt with a promenade tile or a clay tile. Or perhaps a resin something or other could waterproof and surface in one go?
I know this is an odd one. Basically its a house on a steep hill. Road is at top with a drive going into an elevated garage. Under the drive and garage are areas being converted into the house.
Ideas much appreciated.
Pete
