The Brew Cabin

Posted: **Fri Sep 14, 2007 1:01 pm**

Hello,
I have a client who wants to render a brick wall, the top of which steps down in curves. My contractor is concerned that the angles of the curves are too tight for the angle bead used to hold render in place. Any ideas how this can be done?

thanks

Posted: **Sat Sep 15, 2007 12:14 am**

Nip the beading with tin snips every few cm? Either that or form the square edge of the curve by hand as the render mix goes off? Is coping the curved top an option?

The Brew Cabin

Rendering a curved wall