Page 1 of 1
Posted: Mon Mar 21, 2005 12:19 am
by Vic
Has anyone used a mortar gun for pointing work? not the pressure type, the fill yer own type. I have a full house to repoint, and thought about getting one to speed the process up a bit. They'll be 20mm deep joints. What kind of coverage a day can you get with em?
I imagine you have to get the mix pretty wet to go through the gun, and be canny not to get gobo all over the faces.
What's yer opinion, are they worth utilizing or shall i just stick to the old hawk and trowel?
Cheers
Vic
Posted: Mon Mar 21, 2005 8:42 am
by Tony McC
I'm not a fan, although that may be because the hawk'n'trowel method works for me. I;d be interested to hear if brickies or pointing contractors rate them.
Versions of pointing guns are being pushed for paving works, too, and the prices mentioned scare the bejaysus out of me!
Posted: Mon Mar 21, 2005 7:21 pm
by alan ditchfield
tried one once but no matter how we mixed the mortar it tended to work well for the first few squezes and then what was left inside the gun was compacted as all the water came away at the begining.
Posted: Fri Apr 01, 2005 4:46 pm
by Riggers
Pain in the rear end and use far too much muck! Most of it gets onto the ground as you clear up the joint with the trowel. As Tony says, use the hawk and trowel method, loads easier and far more cost effective.
Hope that helps and all the best...............Riggers
Posted: Fri Apr 22, 2005 10:42 pm
by marcscorp
the way to get these to work is to use a plastiser in with it and they work a treat ive just done my gable end, took me a few days to complete but it was a lot easier than using a hawk and trowel.
Posted: Fri Apr 22, 2005 11:58 pm
by Tool
yeah you need plasterzier in the mix other wise its a waste of time, i am not a fan of them but i aint a fan of pointing, its so boring lol
Rather pay the labourer for that job