Page 1 of 1
Posted: Thu Aug 08, 2019 4:45 pm
by jwill
Are there any restrictions on using these flush invert IC's for foul runs? If I buy a 3 inlet flush invert IC and only use the straight run and one side is that likely to cause blockages or is it acceptable?
Posted: Tue Aug 13, 2019 7:31 pm
by Tony McC
No - but you should stopper-up the unused branches.
Posted: Sun Aug 25, 2019 3:35 pm
by jwill
Got a couple of the OSMA 250mm ones. Not only is the unused branch stoppered but on the inside it has a plastic piece which stops any flow going up the unused branch. Quality stuff.
Also for one of the IC's i've again gone with the OSMA 320mm base but with only 2 inlets 1 straight and 1 90deg. You have to get this the right hand for your job but not going to get any nasty pieces clinging on anywhere they shouldn't