The Brew Cabin

Posted: **Mon Apr 02, 2018 6:22 pm**

Hi,

I just bought a bottle trap but I'm unsure about the connection. One side is standard push fit - you can see this in the image it is on the far side with the black ring around it. Each of the other three accept a 110mm pipe inside of it, but there is no rubber seal.

image

How am I supposed to seal these? I thought they can't be solvent weld as this brown pipe isn't solvent weld pipe

If it helps it is a hunter DS41 (p19 Hunter catalogue)
I just got it from wickes.

Thanks,
Dan

Posted: **Mon Apr 02, 2018 9:29 pm**

Ah I think that the idea is that the hole is drilled and then a pipe is inserted and it overhangs inside the chamber so that water falls directly into the bottle. If anyone has seen one before and could confirm I'd still appreciate the confirmation!:)

Posted: **Tue Apr 03, 2018 6:56 am**

Use a flexi collar. Also don't overhang into gully

Posted: **Tue Apr 03, 2018 9:43 am**

Thanks. Lifesaver! I'll do that.

Posted: **Tue Apr 03, 2018 1:37 pm**

Normally it is solvent welded but never seen anyone do it, most guys just push it home. If doing a lot, solvent weld would be my choice, also easy to push on if in brickwork but for one off flexi will do.

Posted: **Tue Apr 03, 2018 10:53 pm**

its a roddable inline gully
so a gully in the middle of a run to another gully maybe
cheers LLL

The Brew Cabin

Advice for connection type 110mm - Bottle gully one end push fit the other?