Page 1 of 1
Posted: Wed Jul 27, 2016 10:37 am
by rks
Hello i'm having difficulty in getting a 160mm square hopper , phoned around a lot of places , is ther no such item in this size ? im assuming i have to keep to same the size as there is a fitting about 1foot below the surface of paving and i want to bring it up to level with paving ,
thanks for any info
Posted: Wed Jul 27, 2016 11:49 am
by Tony McC
Is that the one to take a 150mm square grating? In clayware? I can't understand why they are so hard to find. They used to be a standard fitting, and I've not heard anything about them being superceded.
Posted: Thu Jul 28, 2016 7:41 am
by rks
hello thanks for reply i have linked a photo , I want to raise the drain , make it a lot neater with the pipes ect
and have taken the grill off for clarity , i have measured the outside diameter and and it turns out to be 160mm , I was thinking if i could get a 160mm extender so i can raise the drain and have a sqaure hopper on top so i can get it to the level of the paving ?
I have called so many plumbers merchants even elliots they dont seem to do one .
thanks
http://i1380.photobucket.com/albums....cr0.jpg
Posted: Thu Jul 28, 2016 10:49 am
by seanandruby
You may have to buy a gully and pull the hopper off and raise your 150 pipework then push the hopper and grating into it, job done. I have a one surplus ro requirements.
Posted: Thu Jul 28, 2016 11:19 am
by Tony McC
Our good friends at Plastics Express do a 160-110mm reducer see here which you could put on to the existing then use a standard 110mm hopper to accept the kitchen waste pipes.
Plastics Express offer a 10% discount to users of pavingexpert - just quote PAVE1 (upper case) on your order and save money ..... almost enough to buy me a pint! :~)
