Page 1 of 1
Posted: Sun Dec 16, 2012 11:53 am
by Davydov
Hi everyone first post on this forum. I'm adding new soil pipe witch runs from back garden outbuilding to existing house drain witch is 18 meters,by the end pipe drop is 30cm below ground .But my existing drain pipe drops 10cm in to concrete and then bends in pictures I will show Q How do I connect new to old ? https://picasaweb.google.com/1132308....2248530 https://picasaweb.google.com/1132308....4653010 https://picasaweb.google.com/1132308....0607394 https://picasaweb.google.com/1132308....0798658
Posted: Sun Dec 16, 2012 12:14 pm
by seanandruby
pictures not showing here.
Posted: Sun Dec 16, 2012 12:26 pm
by msh paving
No piccys showing,please repost MSH 
Posted: Sun Dec 16, 2012 12:48 pm
by Davydov
Posted: Sun Dec 16, 2012 1:24 pm
by msh paving
to connect plastic pipe to clay you will need a adaptor fitting, which uses jubilee clips to clamp the rubber onto the clay pipe, you local merchant will know them as a "AC4000" clay to plastic 100mm fitting, MSH
Posted: Sun Dec 16, 2012 5:49 pm
by Davydov
Do I need manhole close to existing conection for this project or can this manhole be close to my outbuilding witch is 16 meters way ?
Posted: Sun Dec 16, 2012 6:07 pm
by msh paving
if the pipe line changes direction and is sewage yes you do,
if not no MSH
Posted: Sun Dec 16, 2012 8:51 pm
by Tony McC
I'd be tempted to put an access chamber in. It makes future access so much easier and is pretty simple to install.
The adaptor couplings that MSH mentioned are shown here