Page 1 of 1
Posted: Thu Apr 26, 2007 6:23 pm
by DavidJ19
Hello
Is an adapter available to connect a plastic 110mm pipe to the socketed end (female?) of a clay pipe?
The clay pipe is in an auckward position to cut so any way of coupling would be of help.
David
Posted: Thu Apr 26, 2007 6:57 pm
by bobhughes
Any decent BM should have one
Bob
Posted: Thu Apr 26, 2007 9:35 pm
by lutonlagerlout
i would add a section of hepsleve or super sleeve to the female connection ,in the traditional way with 3:1 mortar and use a clay to plastic adaptor say 30mm away
always a pain in the backside connecting new platic to old clay
cheers LLL 
Posted: Tue May 08, 2007 8:37 pm
by wingy73
you need an AC4000 flexi-seal will keep invert levels the same, can't you cut it with 4 inch grinder? frazer civil supplies or keyline should be able to sought you out
Posted: Sun Jun 10, 2007 8:30 am
by Dave_L
It's all gone very quiet from DavidJ19 - perhaps he's stuck at Junction 19?? 
This is what you need.....hopefully you are all sorted and backfilled by now!
http://www.flexseal.co.uk/products/fl-adaptor.htm