Posted: Thu May 12, 2005 8:14 pm
In the process of replacing a P trap old toilet with a new one in the downstairs cloakroom. The old connection goes straight down through the concrete floor and into an IC immediately outside - Inspection Chamber Pic (thought I'd attach a picture - I don't think enough get posted in the forum!)
My thinking is that the new soil pipe will come out of the back of the toilet, through the wall, into a 92.5 bend into the ground, into a soil stack bend and into the chamber, replacing the existing clay pipe. However, as you can see, its very tight.
Is there an easier way of doing this, or am I going to have to take the chamber apart brick by brick on the far side to make enough access. Thanks in advance!
(ps, yes, those 32mm pipes in the picture do end up in the IC - I've just moved into this house of horrors!!)
My thinking is that the new soil pipe will come out of the back of the toilet, through the wall, into a 92.5 bend into the ground, into a soil stack bend and into the chamber, replacing the existing clay pipe. However, as you can see, its very tight.
Is there an easier way of doing this, or am I going to have to take the chamber apart brick by brick on the far side to make enough access. Thanks in advance!
(ps, yes, those 32mm pipes in the picture do end up in the IC - I've just moved into this house of horrors!!)