The Brew Cabin

Posted: **Sun Mar 20, 2005 7:06 pm**

i'm in the process of building an extension and my footings fall right on my drains (salt-glaze). I'm just wondering the best way to turn corners - can it be done with long-radius bends ort isd it better to put an IC in at every turn. I'm planning on starting the new pipework with a MH so i can feed the current soil stack and new WC waste in, but i'm a bit stuck from there on.

Any help would be appreciated
Thanks

Stu

http://putfile.com/pic.php?pic=3/7813045915.jpg&s=x2

Posted: **Mon Mar 21, 2005 8:47 am**

You should always use a MH or IC at any sharp charnge of direction. I can't quite tell from your drawing where exactly the IC would go, but I'm guessing you mean the top RH corner of the sketch.

The Brew Cabin

Turning corners