The Brew Cabin

Posted: **Thu Jul 11, 2019 2:53 pm**

Hello guys
Please can you advise.
House built on a slope. So we have a rear patio area made from beam and block - about 40m2.

Have bought sandstone slabs of mixed sizes. Biggest 90@x600. Wondering whether you could guide me on best way to bed sandstone onto beam and block? The beam and block bounces and moves in small amounts, as do most, and thinking of damage to adhesion and joints.

- will a mortar bed be sufficient?
- should it be screeded first?
- should I go with a BAL type flexible product straight onto beam and block?

Any advice very welcome on how you would do it
Cheers
Matt

Posted: **Tue Jul 16, 2019 9:33 am**

I'd be more concerned with ascertaining why the B&B floor is moving, It should be more-or-less completely stable. You can sometimes get minor wobbles when a bit of grit or similar has lodged benath one of the blocks, but other than that, there should be no movement. Sort that first!

The usual process then would be to lay a DPM, insulation (if necessary) then a screed of sand/cement, and finally the paving itself.

But all this depends on the B&B being stable. Any movement therein will only be transferred through to the eventual paving layer.

Posted: **Thu Jul 18, 2019 10:45 pm**

Thanks for your guidance, much appreciated.
The B&B has some flexibility as itâ€™s 4750mm long, the max span without support.You can feel small movement if you jump in the centre. I have now screeded the surface.

Would you use a flexible adhesive or a mortar bed for the sandstone slabs?

Posted: **Fri Jul 19, 2019 10:16 am**

Mortar bed - there's nothing to be gained by using a flexible adhesive

Posted: **Wed Jul 15, 2020 12:04 pm**

Hi, can anyone advise on the type/thickness of screed required. The area is under a roof canopy, b&b floor 1.8m x 15m, finished in 35mm thick sandstone.

Posted: **Wed Jul 22, 2020 12:09 pm**

Apologies for delayed response - been in hozzy for a few days.

It's usually 50mm or thereabouts

The Brew Cabin

Slabs on beam and block - advice needed - Slabs on beam and block