Posted: Fri Aug 18, 2017 8:28 pm
Hi Folks,
Thanks for having me.
I'm just about to embark on laying a 3m x 3m riven-effect concrete patio. I've done all the prep with a good amount of sub-base and have bought about 6 bags of sharp sand and 4 cement; I'm intending to go with a full mortar bed.
My question is whether I can lay a few slabs and then pick it up a later date (i.e. split the laying process over a couple of days)? My main reasons for approaching this way are:
1. I don't drive and would need to get the extra sand and cement delivered (and a jumbo bag doesn't fit down the side alley)
2. I'm a complete novice, so spanning a few days would give me chance to review my methods and take my time getting it right
3. Weather
4. Slightly dodgy knees
If it's feasible, how would I make sure the new mortar bed binds in with the existing mortar (under the slabs I would've laid in a previous session)?
I've hunted high and low with a plethora of search terms but I can't find any information.
If all of the slabs need to be laid in one session, so be it, I'll just have to wait until I've got enough sand and cement to do the whole lot and get up extra early
Many thanks.
Thanks for having me.
I'm just about to embark on laying a 3m x 3m riven-effect concrete patio. I've done all the prep with a good amount of sub-base and have bought about 6 bags of sharp sand and 4 cement; I'm intending to go with a full mortar bed.
My question is whether I can lay a few slabs and then pick it up a later date (i.e. split the laying process over a couple of days)? My main reasons for approaching this way are:
1. I don't drive and would need to get the extra sand and cement delivered (and a jumbo bag doesn't fit down the side alley)
2. I'm a complete novice, so spanning a few days would give me chance to review my methods and take my time getting it right
3. Weather
4. Slightly dodgy knees
If it's feasible, how would I make sure the new mortar bed binds in with the existing mortar (under the slabs I would've laid in a previous session)?
I've hunted high and low with a plethora of search terms but I can't find any information.
If all of the slabs need to be laid in one session, so be it, I'll just have to wait until I've got enough sand and cement to do the whole lot and get up extra early
Many thanks.