Posted: Thu Oct 30, 2014 9:29 am
I have installed gftk 2-part vdw815 which has gone down well and looks good. However, as the tiles dried after being wet there is a quite a large amount of residue left on the tiles - especially near the edges - a picture frame effect. I spoke to NCC who said I didn't use enough water and so the product was not free flowing enough - essentially as I was pushed it around with a squegee it was leaving glue residue on the tiles.
Does anyone have any suggestions for removing the cured residue, someone mentioned petrol was good for hardened glue. Obviously I will use a test piece first but any other ideas??
Picture here
So disheartening to have done all the hard work and for a poor result!
Does anyone have any suggestions for removing the cured residue, someone mentioned petrol was good for hardened glue. Obviously I will use a test piece first but any other ideas??
Picture here
So disheartening to have done all the hard work and for a poor result!