Page 1 of 1
Posted: Fri Oct 20, 2006 5:38 pm
by ibw123
My tarmac drive is on a 1 in 10 upslope from my house to the road. The pavement crossover is of a concrete composition and a low spot has developed where the tarmac drive meets the crossover, possibly due to the fact that I now have a 1.5Tonne Jaguar. The low spot means that the bottom of the car scrapes the drive. I need to raise the low spot by only 1 inch or so in an area of approx 24"x24".How can this be best achieved?
Posted: Fri Oct 20, 2006 6:12 pm
by lutonlagerlout
if its the public footpath you will need to contact your local council highways department and tell them there is a sunken footpath (trip hazard)if it is your land dig the falgs up and bed them up an inch with a 1:10 cement sharp sand mixture
i think it is illegal to touch a public footpath now so best check mate
cheers LLL 
Posted: Sat Oct 21, 2006 1:34 pm
by Dave_L
Can you post up a picture of the sunken area?