The Brew Cabin

Posted: **Mon Jun 22, 2009 10:58 pm**

Hi,
We recently laid a patio with Bradstone indian Sandstone. Then started to point with Geofix (never used this product before). Whilst brushing it in we noticed that the residue was staining the surface of the paving. It has now been down 24 hrs and it is still stained. I rang the manufacturer and they said that this can happen depending on the porosity of the stone and that it should disappear after a couple of days. I'm not convinced though, as the marks are very engrained. Has anyone had a similar experience? Can i really expect the problem to improve over time?

cheers

Posted: **Mon Jun 22, 2009 11:51 pm**

The stuff is rubbish,check the forum for posts about it,you will never hear a good word for the stuff, MSH

Posted: **Tue Jun 23, 2009 7:12 am**

It is rubbish, but the sheen left after sweeping it in does indeed disappear after a few days. Don't worry you'll be pulling it out in a few months to re-do it with something decent.

Posted: **Tue Jun 23, 2009 7:26 am**

Great, that's a relief. Only did about 2 square metre area luckly. So will be pulling it out. What is the best tool to get it out with? A pointing iron perhaps?

thanks again.

Posted: **Tue Jun 23, 2009 8:10 am**

Anything! A screwdriver, spoon, stiff brush! Getting it out's not the problem, it's trying to keep it in!!

The Brew Cabin

Geofix - Staining problem