The Brew Cabin

Posted: **Tue Dec 09, 2008 12:18 pm**

Hello

I have long been a lurker on this forum and thought its about time that I registered!

I have a number of broken ABS paving moulds, mainly side splits and corners. Instead of buying new, I wondered if there was anything on the market which can be used to repair.

All information grately received.

Posted: **Tue Dec 09, 2008 1:24 pm**

As far as I know you would have to get your hands on a particular welding gun that fuses/melts the split, I've seen it used on polyprop (I think) pipe jointing - you would need to repair quite a few to warrant the cost. If there is a glue that works its going to be a speciality type, if you are trying to save money experiment. I've also repaired minor blemishes with a heated poker. With the moulds so reasonable in cost - I use Harristone (Brilliant) - buy new - carefully looked after they last 4 years and longer. Also you can rigidise your moulds by placing them in custom made wooden trays, saves big bucks in the long run.

The Brew Cabin

Paving mould repair advice - Paving moulds