Posted: Tue Jul 29, 2008 8:35 pm
Will be doing as job with sawn (4 sides) not top indian stone.
It seems to work perfect with a 10mm joint which is nice.
Imo the joints are too narrow and not in keeping with doing a weatherstruck joint as the finish surface though not diamond sawn is no where near as tumbled as the usual un sawn stuff.
Therefore i,m looking to maybe use one of these resin based joint materials (obv not geofix :O ) which can perhaps be swept in and just struck off with maybe a piece of wood so the joint is flat and flush.
Any ideas?
cheers
It seems to work perfect with a 10mm joint which is nice.
Imo the joints are too narrow and not in keeping with doing a weatherstruck joint as the finish surface though not diamond sawn is no where near as tumbled as the usual un sawn stuff.
Therefore i,m looking to maybe use one of these resin based joint materials (obv not geofix :O ) which can perhaps be swept in and just struck off with maybe a piece of wood so the joint is flat and flush.
Any ideas?
cheers