The Brew Cabin

Posted: **Fri Nov 23, 2007 3:27 am**

Hi All,
We are using 500x500 textures concrete pavers with a bullnose edge which overhangs the pool by up to 50mm. I am looking for advice on the best way to mortat/grout these bearing in mind that:
1. They will be subject to a lot of water splashing
2. the filling in the overhang will need support of some sort while it sets
Thanks

Posted: **Fri Nov 23, 2007 9:00 am**

Hi

Standard Easipoint will do the job, it's waterproof and won't slump so no support will be necessary. Check our web site www.easipoint.co.uk

Cheers

Sue

Posted: **Fri Nov 23, 2007 9:49 am**

Hi again,
Do you have a supplier in New Zealand?
Thanks

Posted: **Fri Nov 23, 2007 3:13 pm**

Hi

Sorry didn't check where you were from - no we don't have anyone there

Sue

Posted: **Fri Nov 30, 2007 5:23 pm**

Given there's no Easipoint available, I'd suggest a SBR-enhanced mortar. SBR is a widely used additive so should be available from most builders suppliers over there.

The Brew Cabin

Grout/mortar on pool surround - How to grout/mortar concrete pavers arou