Page 1 of 1
Posted: Fri Aug 25, 2006 8:54 pm
by Asprey
Hi Guys
Just after some info, whats the best thing to cut natural sandstone? I have a hand held grinder. Can i do it with that? I have tried to cut it before with a stone cutting blade but it was very tough stuff. Any suggestions?
Thanks
Posted: Fri Aug 25, 2006 11:17 pm
by Mark B
depends on how many flags etc you need to cut and the size of the grinder your using, if your goin to be doing many cuts and the grinder youve got is of a good size then buy a dimond tipped blade, will outlast an abrasive blade many many times, bit more expensive at first but costs more on the long run and the cuts will be neat.
splitters can also be used but not so good if youve got riven flags with the uneven surface.
if you grinders not big enough for the job then you can hire a cut off saw or grinder for the wkend and just leave all your cuts to the end and do them all at once saving you from hiring out the tool more than once
cheers, Mark
Posted: Sat Aug 26, 2006 12:12 am
by lutonlagerlout
a stihl saw with a13 " diamond blade and a water attachment makes micemeat of natural stone (we have 2 ts 400s)need a steady hand though and the safety gear
regards tony 
Posted: Sat Aug 26, 2006 5:25 pm
by Asprey
Cheers guys, thanks for the advice. I think i will try the diamind blade first.
Thanks again
Darren