Posted: Fri Apr 01, 2005 8:14 pm
Hi All,
newbie here - seeking advice please
I have recently purchased a quantity of Indian Sandstone flags and have a query about how flat the surface of the flag should be.
I appreciate these are natural stone and therefore would not expect a finish any where near that of a patio slab, however I was surprised at the number of flags that had quite large dips/grooves etc. Some of the flags have large grooves/dips over 10mm deep.
Is this to be expected or should I still expect the flags to fit within
certain tolerances
Any advice would be appreciated
rgds
Andy
newbie here - seeking advice please
I have recently purchased a quantity of Indian Sandstone flags and have a query about how flat the surface of the flag should be.
I appreciate these are natural stone and therefore would not expect a finish any where near that of a patio slab, however I was surprised at the number of flags that had quite large dips/grooves etc. Some of the flags have large grooves/dips over 10mm deep.
Is this to be expected or should I still expect the flags to fit within
certain tolerances
Any advice would be appreciated
rgds
Andy