Posted: Sun Jun 07, 2020 9:55 am
I am planning on using sandstone pavers to relay my driveway (35m^2). I have already got my geotextile and subbase done and I was planning on bedding directly on a 100mm bed 3:1 mix, however I was going to have help with the mixing but with the current situation I will be doing it on my own, so am considering the indirect bedding method.
As I had only left for a total 100mm bed, would it be ok to have a 70mm concrete base then 30mm mortar?
If so how do I create the concrete base? 3:1 mix and tapped down with straight edge? Can it be a semi dry mix?
Or does it have to be the pre-mixed delivered type?
I’ve already got enough sharp sand for the 100mm base so hence why I would prefer to make/mix the base myself.
Any advice would be greatly appreciated.
As I had only left for a total 100mm bed, would it be ok to have a 70mm concrete base then 30mm mortar?
If so how do I create the concrete base? 3:1 mix and tapped down with straight edge? Can it be a semi dry mix?
Or does it have to be the pre-mixed delivered type?
I’ve already got enough sharp sand for the 100mm base so hence why I would prefer to make/mix the base myself.
Any advice would be greatly appreciated.