Repair
Posted: Sat Sep 20, 2025 2:42 pm
I have a large drive, laid by certified contractor, but unfortunately in 2 areas the paving has sunk slightly... not huge, around a dozen Paviors affected in each location.
These are Blockley Clay 50mm Paviors
If I pull out affected Paviors, I will need to top up the sharp sand and then wacker plate them back in .... I have access to wacker plate.
Anybody advise what depth I should top up to .... i.e how far down from face of the correct level paviors.
These are Blockley Clay 50mm Paviors
If I pull out affected Paviors, I will need to top up the sharp sand and then wacker plate them back in .... I have access to wacker plate.
Anybody advise what depth I should top up to .... i.e how far down from face of the correct level paviors.