The Brew Cabin

Posted: **Sat Dec 31, 2005 5:21 pm**

I want to produce (in plastic moulds ABS) concrete slabs. Unfortunately, the surface of my slabs is shiny. I've seen slabs, aslo produced in such moulds, but they were flat.
Is there a way to achive the flat effect?
Thank you for any piece of information.

Posted: **Mon Jan 09, 2006 4:38 pm**

The interior surface of your moulds dictates the finish of your slabs - if they are shiny, you will get shiny slabs.

The Brew Cabin

Flat surface of concrete - How to achieve it?