Posted: Sat Feb 29, 2020 9:40 am
Hi, I've had the driveway (120 m2) dug out and stoned up but the lad with the mini digger dug a bit too much out. It's had 21 ton crush so far and wacked and is about 100mm deep and it's between 100 - 120mm down from finished level. I'm going to be laying 50mm Tegulas so that leaves me needing between 50 - 70mm for the grit sand.
Is that too deep for grit sand ?
I could either top it with 30/40mm more Crush and then 30mm grit sand or just make it all up in grit sand.
Either way the cost per loose ton is the same, except that it will be easier to shift (and level) grit sand than stone as the digger lad has been paid & gone so it's all manual shifting now, and it's a big area, 120 m2
If I go with all grit Sand I can get 20 ton in one drop, level & wack it, in stages, ready for the blocks, as opposed to paying for a smaller amount of crush, wack it and then grit sand to be dropped off separately. But then I'm into minimum quantities per load which I think is 10 ton.
Whichever route I go it's going to be thoroughly wacked down and the edges are all in place and solid so nothing can move laterally.
My question is this, from a structural point of view, is there any difference laying the Tegula block paving on 30mm, 50mm or 70mm wacked grit sand as long as there's sufficient wacked hardcore underneath it or does more sand potentially cause sinkage even though it's wacked hard ?
thanks
Is that too deep for grit sand ?
I could either top it with 30/40mm more Crush and then 30mm grit sand or just make it all up in grit sand.
Either way the cost per loose ton is the same, except that it will be easier to shift (and level) grit sand than stone as the digger lad has been paid & gone so it's all manual shifting now, and it's a big area, 120 m2
If I go with all grit Sand I can get 20 ton in one drop, level & wack it, in stages, ready for the blocks, as opposed to paying for a smaller amount of crush, wack it and then grit sand to be dropped off separately. But then I'm into minimum quantities per load which I think is 10 ton.
Whichever route I go it's going to be thoroughly wacked down and the edges are all in place and solid so nothing can move laterally.
My question is this, from a structural point of view, is there any difference laying the Tegula block paving on 30mm, 50mm or 70mm wacked grit sand as long as there's sufficient wacked hardcore underneath it or does more sand potentially cause sinkage even though it's wacked hard ?
thanks