Page 1 of 1
Posted: Wed May 15, 2019 8:40 am
by dave1965
What is the correct method for installing paving blocks into the recessed tray ? Do I just bed them on sand as with the rest of the drive and compact down with the other blocks, or do I stay away from the tray with the wacker plate ?
Posted: Wed May 15, 2019 4:55 pm
by doobin
Stay away with the wacker, it'll just bounce. Sand can be used if needed to get the levels perfect, but I try to get the tray set perfect and just sit the blocks in with some co-polymer grab adhesive to stick them to the tray.
Posted: Thu May 16, 2019 8:39 am
by dave1965
Thanks for the reply, is there a particular brand/type of adhesive that you would recommend?
Posted: Fri May 17, 2019 2:06 pm
by Tony McC
Most trays are slightly deeper than blocks so some form of bedding is usually required.
You could use grit sand, same as used for bedding blocks on the main pavement, or even a mortar mix (say 6:1 semi-dry). With a plastic frame, the plate compactor will bounce, so best to assemble the tray on a solid surface and use a mallet to compact blocks, then offer the paved tray into the frame.
When bedding onto sand, I usually drill a couple of 10mm dia holes in the base of the tray about 50mm or so from opposite corners, then line the tray with a permeable, non-woven, construction grade geotextile before placing the bedding and fixing the blocks. This allows any water that finds its way into the tray to also find its way out again and prevent the tray looking damp long after the rest of the pavement has dried out.
Posted: Sat May 18, 2019 7:35 am
by dave1965
Thanks Tony, all makes sense, I will give this method a go. I did wonder about how the tray would drain