The Brew Cabin

Posted: **Fri Oct 19, 2018 12:18 pm**

So, we have had our awful PIC driveway dug out and a new block paved driveway installed.

Installers were good and knew what they were doing and we are quite happy with the drive. However there is an issue where we had one block where a metal wire has protruded out of it. Installer returned and swapped the block out for a new one.

Now we have found a second block with a metal wire sticking out of it and we are concerned not only that these blocks maybe sub standard, but also that we are going to end up with punctures on our cars.

https://ibb.co/jWA6af - link to picture.
Link to picture

Has anyone come across this before?

Is this likely to happen with the whole lot?

Thanks

James

Posted: **Fri Oct 19, 2018 8:13 pm**

Anybody?

Posted: **Sat Oct 20, 2018 9:30 pm**

Think of yourself as the chosen one, the only one ever too see something like this before lol. Most likely a factory contamination that will never happen again, you would be surprised by the technology used in concrete mixing :p

Posted: **Sun Oct 21, 2018 1:07 pm**

Haha, the chosen one lol....... Well, a member of the quality team at Tobermore is going to get in touch so will see what they say.............

The Brew Cabin

Tobemore block paving - wire sticking out of block - Wires sticking out of new block pavers.