Page 1 of 1

Posted: Sun Jun 19, 2016 10:50 am
by r4vvm
Hi,

I know this has probably been asked a million times but could not find anything in the search.

Is there a weed killer i can put on my block paving driveway to kill all the weeds.

I am always pulling them out every few weeks, but my driveway is quite big and would be easier if i can just spray the whole drive to kill these.

Thanks

Posted: Thu Jun 23, 2016 8:33 pm
by Tony McC
Pathclear, glyphosate....any good quality brand will do it.

Sodium Chlorate used tio be the death juice of choice but it's not legel for civilians any longer (and rightly so!)

Posted: Tue Jun 28, 2016 1:15 pm
by PavingSuperstore
Think Glyphosate is going the same way....

Posted: Wed Jun 29, 2016 9:25 am
by Tony McC
Is it? What will we have left? Salty water???

I'm curently battling an invasion of Mare's Tails from my new-ish neighbour, who, unlike the previous occupant, has buggerall interest in maintaining the garden and is letting it revert to meadow. This is what happens when I'm denied the power of veto over potential new neighbours!

Anyway, glyphosate is the only thing I've found that will travel down to the roots and kill the whole thing, not just the bit above ground level.

Posted: Mon Jul 04, 2016 5:31 pm
by r4vvm
Thanks - where is the best place to get it from?

Posted: Wed Jul 06, 2016 12:07 pm
by Tony McC
Any of the DIY sheds, I suppose.

I got a big 5 litre pack of Resolva from Costco at the start of Spring and it's lasted me well enough.

Posted: Mon Jul 11, 2016 2:04 pm
by r4vvm
whats the best way to apply Glyphosate

Posted: Tue Jul 12, 2016 12:33 pm
by Tony McC
Spray, if suitable, or via fine rose

Posted: Thu Jul 14, 2016 6:31 am
by angeldale
Which paving is good? Asphalt or Blacktop?

Posted: Thu Jul 14, 2016 11:27 am
by Tony McC
Good for what?

And why raise this in a discussion about block paving?

Posted: Fri Jul 15, 2016 12:57 pm
by r4vvm
Thanks - When i spray this on my drive way.
Would it be ok to jet wash the drive day after or should i wait a week for it to kill all the weeds?

Posted: Sat Jul 16, 2016 7:18 am
by Dave_L
Weedkill it and leave at least 3 weeks for it to work into the root structure, then remove all weeds. Not a fan of pressure washing CBP, it takes the fines out of the face of the blocks and makes them rougher which helps moss etc take hold!