Posted: Wed Jun 16, 2010 9:04 am
I'm laying Tobermore 50mm Tegula setts in smallish irregular area for a path. The area is approx 1.2m wide by 10m long and is bounded by walls on 3 sides. The path isn't straight, it snakes a bit.
I tried using a wacker to do the final compaction but found it was near impossible to turn around at cul de sac end and to follow the curve. I then tried doing it by hand with a small rubber mallet; that was reasonably successful, I've got about 3m done but I got repetitive strain injury so that has to be abandoned.
Any ideas?
I tried using a wacker to do the final compaction but found it was near impossible to turn around at cul de sac end and to follow the curve. I then tried doing it by hand with a small rubber mallet; that was reasonably successful, I've got about 3m done but I got repetitive strain injury so that has to be abandoned.
Any ideas?
