Block paving & dpc advice - Too close for comfort

All forms of block paving, brick paving, flexible or rigid, concrete or clays, new construction or renovation
Post Reply
Nokey
Posts: 4
Joined: Fri Oct 30, 2009 3:42 pm
Location: Hants

Post: # 42666Post Nokey

Hi All,

I'm looking for a bit of advice, I've had my driveway block paved this week and have been overall very pleased with the work carried out until today. Now that they have finished he full driveway I am concerned, after reading this forum, that the block paving is nowhere near the 150mm required depth below the DPC as you can see from the photo's below.

I have spoken with the contractor and he's coming round tomorrow to discuss the options, he says that it's fine as he's put in a fall away from the house.

I would appreciate your advice on what are the best options to proceed with.. would digging out a channel between the paving and the house be the best solution?

Thanks in Advance

Nookey
Image
Image
Image
Image
Image

rab1
Posts: 1869
Joined: Sun Jun 07, 2009 10:19 pm
Location: scotland

Post: # 42667Post rab1

I`d be concerned that they have covered part of the air brick as this is designed to allow the area between you foundation and suspended floor to breath. but i`m sure someone more qualified will be able to offer more help and advice.
God loves a tryer

ambient
Posts: 393
Joined: Fri Jun 13, 2008 6:20 pm
Location: bolton lancs
Contact:

Post: # 42681Post ambient

fall away from house or not doesnt matter but it must be 2 courses down from dpc and then fall to grids or aco or away from house have they installed drainage for current legislation ???
ambientdriveways.co.uk ambientexcavations-bolton.co.uk

Nokey
Posts: 4
Joined: Fri Oct 30, 2009 3:42 pm
Location: Hants

Post: # 42685Post Nokey

Thanks for the replys, they have installed a drain approx 8"x8". What do you think is the best solution to rectify?

lutonlagerlout
Site Admin
Posts: 15184
Joined: Fri Aug 04, 2006 12:20 am
Location: bedfordshire

Post: # 42689Post lutonlagerlout

the local council accept 100mm below DPC if the paving is falling away at a good rate i.e. 1:40
sadly your drive looks too high
this is not an easy issue to remedy, have you a contract? was dpc height mentioned beforehand?
from my study it looks a fair job apart from the levels,
LLL
"what,you want paying today??"

YOUR TEXT GOES HERE

Nokey
Posts: 4
Joined: Fri Oct 30, 2009 3:42 pm
Location: Hants

Post: # 42698Post Nokey

LLL thanks for your post... I don't have a contract, just a quote which doesn't mention the depth below the DPC.

I had discussed with contractor the fact that the previous drive was higher than it should have been (but not as high as it is now) and it would need to be lowered but I don't have anything in writing.

I went with a Marshalls approved installer to give me some confidence that I would get a good job, and to be fair I have been pleased with the rest of the work.

I guess I'll wait and see what he says tomorrow.

Regards
Nookey

ambient
Posts: 393
Joined: Fri Jun 13, 2008 6:20 pm
Location: bolton lancs
Contact:

Post: # 42705Post ambient

complain to marshalls they have area inspectors who will come out and have a look the one we have in north west is a retired paver he would not accept this and it is definitely not to their regs ???
ambientdriveways.co.uk ambientexcavations-bolton.co.uk

Nokey
Posts: 4
Joined: Fri Oct 30, 2009 3:42 pm
Location: Hants

Post: # 42718Post Nokey

All, thanks for your comments and advice.

My contractor was happy to address my concerns and will rectify with a channel between the house and additional kerbing.

Great website BTW.

ambient
Posts: 393
Joined: Fri Jun 13, 2008 6:20 pm
Location: bolton lancs
Contact:

Post: # 42719Post ambient

what?
ambientdriveways.co.uk ambientexcavations-bolton.co.uk

Post Reply