Page 1 of 1
Posted: Tue Aug 25, 2009 1:01 pm
by RSVr
I have 30M2 of 12x12 to joint up................eventually lol
I have been offered some 0.2 sand or I have seen some pavefix.
How much of the stuff would i need?
Thanks
Posted: Tue Aug 25, 2009 5:22 pm
by dig dug dan
depends on joint width tbh and sizes of slabs.
0.2 should be MORE than enough .
Pavefix? :laugh:
Posted: Tue Aug 25, 2009 8:53 pm
by lutonlagerlout
4 bags of plastering sand and 1 bag of cement should be enough,with 10mm by 38mm joints
not sure what you mean by 0.2 sand?
LLL ???
Posted: Tue Aug 25, 2009 9:07 pm
by msh paving
I think he's working on .2 cubic m sand about 3 barra loads MSH
Posted: Wed Aug 26, 2009 3:25 pm
by RSVr
Sorry lads, I was talking a load of all crap lol
My joints will be around 2mm and they are on 12x12cm surface area is 30M2
The sand is calibrated here in 00 0.1 0.2 0.3 0.4 u get the idea.
ps just laid the blocks on the screeded sand and its started to rain............hope it aint gonna feck the screed up.
Posted: Wed Aug 26, 2009 5:10 pm
by dig dug dan
joints that small cannot be pointed by hand, and are too small for romex.
Kiln dried sand is the only option, and 2 bags will cover it
Posted: Wed Aug 26, 2009 6:02 pm
by lutonlagerlout
ahh zut alors,i forgot RSVr was in the land of garlic
as dan correctly says if it is CBP then KDS is the way forward
bonnait de douche!
LLL