Edge restraints and kerbs

[mcelec]

im hoping to lay my edge restraints and kerbs tommorrow so just after a bit of advice!

the course against the house - do i lay this on a bed of concrete?

the course at the entrance to the drive - do i lay this on a bed of concrete?

also will i be ok to use the concrete just add water bags from the likes of b&q or shall i mix my own?

[slimdotjim]

Yes
Yes
mix your own

[seanandruby]

Ready mixed bags cost a fortune. better to buy it loose, or in ton bags and cement seperate :;):

[matsfc]

no
yes
probably yes

[slimdotjim]

Laying the edge course along the house wall on concrete, makes screeding a hell of a lot easier

[lutonlagerlout]

i dont know anyone that would bed blocks tight to a wall on concrete unless it was a footpath,there is no need if the sub base and bedding layer are correct
the wall provides the restraint
LLL

[slimdotjim]

Perhaps I’ve misunderstood the question LLL, but if I’m building a driveway, I bed the edging along any house walls on concrete, if only to give me something to screed off.
A method promoted on this site.
or maybe the suns fried my brain.

[lutonlagerlout]

of course if you are using the notched board method Jim,
but I have found that any blocks laid on concrete, eventually ,even with only a couple of mm of settlement will stand proud,i.e. the ones around manholes etc
personally I would rather concrete edgings or kerbs around any free edges and keep all the blocks on the same bedding layer /type 1 layer
I used to screed freehand but have used the conduit lately and they are cheap and very useful==> worth a try
all the best
LLL

[slimdotjim]

I've been in this game quite a while now, but always open to different or new ways of doing things, especially if it saves time and money

[lutonlagerlout]

i was dubious about the conduit jim,but it worked well for me,i have used notched boards extensively and screeded freestyle ,but the conduit is more accurate i reckon
LLL

[jay-Manor Driveways]

i only ever bed my edgings on concrete if there is no restraint then i haunch them as well , as for screeding ive always used electrical conduit think they are 20mm steel, they are perfect for the job , ive also got a probst screeding bar thingy that is a god send if you do it every day

[mcelec]

i used 20mm steel conduit (im an electrician so luckily had some in the garage!) it is relatively easy!