Dart and slips with marshalls driveline excel

[carlbeardsmore]

I have a drive that is not square to the road. I want (using Driveline Elite) the pavers to be square with the house so this will mean cutting in at the join with the road.

With 200x100 pavers, I normally cut in using Tonys method of using 1/2 block where needed. You cannot really see them on a herringbone pattern.

How do I cut in if the blocks are layed in a stretcher bond?

I do not want any tiny cuts at one end of the drive entrance.


Cheers Carl

[Pablo]

Don't worry about it I've never had a problem with it and it's totally unavoidable.

[ambient]

I have a drive that is not square to the road. I want (using Driveline Elite) the pavers to be square with the house so this will mean cutting in at the join with the road.

With 200x100 pavers, I normally cut in using Tonys method of using 1/2 block where needed. You cannot really see them on a herringbone pattern.

How do I cut in if the blocks are layed in a stretcher bond?

I do not want any tiny cuts at one end of the drive entrance.


Cheers Carl

on your last row cut the block to fit if its slightly bigger than a row use the large by turning it round length ways till you can get a cut out of a medium when your cut is getting smaller than a third of the block step back a row and use the large ones till you can get a cut out of a medium again

[carlbeardsmore]

Thanks for that ambient. What does it look like when done like this? Does it blend in well?

[ambient]

it blends in well and is only way to do it without ending up with slivers that break when compacted