Expansion joints or not - Are expansion joints necessary
-
- Posts: 1
- Joined: Fri Oct 05, 2007 12:38 am
- Location: Sand Springs OK
-
- Posts: 44
- Joined: Thu Sep 20, 2007 3:47 pm
- Location: c/o The Black Pig, Staple, Kent
Hmmm...probably not best practice, this is saw cut induced joint, normally seen on floor slabs for buildings. More common driveway construction is individually concreted bays with expansion joints between each bay. to be honest, I can't see any reason why you would cut external concrete, but then again, why not? I take it that it is brush finish as a driveway, and to my mind a saw cut in the middle of brushed concrete would not look as neat as a properly formed expansion joint between bays. ask them why they chose this method, or perhaps Tony will enlighten you (and me?)
New and improved...Mk. II...10% simpler...still called Simon!
-
- Site Admin
- Posts: 8346
- Joined: Mon Jul 05, 2004 7:27 pm
- Location: Warrington, People's Republic of South Lancashire
- Contact:
Are we sure this is a concrete driveway? The OP has posted to the block paving section, and I wonder if the paving is a rigid block pavement?
Retro-cut joints in concrete is standard practice in the PIC trade. Given the traffic levels involved, I can't really construct a good argument against their use, but what annoys me is that very, very few are ever sealed after being cut. The contractors seem to think that allowing the cut to be filled with detritus and fag ends will do the job at a fraction of the cost of a poly-sealant.
Retro-cut joints in concrete is standard practice in the PIC trade. Given the traffic levels involved, I can't really construct a good argument against their use, but what annoys me is that very, very few are ever sealed after being cut. The contractors seem to think that allowing the cut to be filled with detritus and fag ends will do the job at a fraction of the cost of a poly-sealant.
Site Agent - Pavingexpert
-
- Posts: 44
- Joined: Thu Sep 20, 2007 3:47 pm
- Location: c/o The Black Pig, Staple, Kent
Made me wonder...but then I read about bringing out the floor saw and I couldn't really see how it could be much else but concrete.
again, why rigid BP on a domestic drive? I've only seen it laid over tarmac for industrial estate roads or freight yards, would be very costly way of going about a bog standard driveway.
again, why rigid BP on a domestic drive? I've only seen it laid over tarmac for industrial estate roads or freight yards, would be very costly way of going about a bog standard driveway.
New and improved...Mk. II...10% simpler...still called Simon!
-
- Site Admin
- Posts: 8346
- Joined: Mon Jul 05, 2004 7:27 pm
- Location: Warrington, People's Republic of South Lancashire
- Contact:
-
- Posts: 368
- Joined: Tue Sep 25, 2007 7:20 pm
- Location: darwen
- Contact:
-
- Site Admin
- Posts: 15184
- Joined: Fri Aug 04, 2006 12:20 am
- Location: bedfordshire