The Brew Cabin

Posted: **Mon Sep 11, 2006 8:54 am**

Hi all

I've had my front garden dug out and stoned up in preporation of having it tarmaced.

It's a very long story but the determining factor was cost - so in the end I thought it would be cheaper to tarmac.

I'm now in two minds again and wondered if I could still go down the block paving route?

basically I had the level set to allow for approx 75mm of tarmac (50mm base course and 25mm wearing course).

Obviously the block paving would require (tell me if I'm wrong) 40mm of bedding sand + the 50mm (or even 60mm) height of the block - so I'm about 25mm+ too high?

I can't get the stone removed and dig out more of the area.

If I go ahead with the block paving, the paving will be approx 25mm higher than neighbouring land and also the front of the drive where it meets a tarmac path.

Any ideas or have I gone too far down the road of tarmac?

Cheers

Wayne

Posted: **Mon Sep 11, 2006 5:36 pm**

Not being a block pave expert I can't offer an opinion......but why have you now steered away from tarmac?

Posted: **Mon Sep 11, 2006 8:48 pm**

if i was you i would get dave l to tarmac it :;):
regards tony

Posted: **Mon Sep 11, 2006 10:06 pm**

Bound to be cheaper than blocks at least!

I guess Wayne is in Feltham? Bit of a journey for us!!!

Posted: **Mon Sep 11, 2006 10:42 pm**

in his profile it says summmmerset,just like you dave

tony

Posted: **Tue Sep 12, 2006 6:38 am**

lutonlagerlout wrote:in his profile it says summmmerset,just like you dave
tony

Ah......how could I miss something so obvious!

Cheers LLL

The Brew Cabin

Sub-base too high...what can i do?