Posted: Tue Sep 05, 2006 9:36 pm
Hi,
I've started on a tarmac driveway replacement project, with the advice I've read on this fantastic site.
However I've become stuck after some hard work removing the tarmac. My hardcore base is at least 20in deep, but is not remotely level, the peak (drive center) is about 4in above the correct level I have achieved at the ends of the drive.
I've tried to address this with a pick axe and have realised this is just not going to achieve results.
I think I could move forward through hiring a digger/skip - but is this unrealistic for a DIY approach ?
I have not had much luck finding a previous post which helps me dcide if this is the right solution or determine the skill level required.
Any advice would be really welcome.
Thanks
I've started on a tarmac driveway replacement project, with the advice I've read on this fantastic site.
However I've become stuck after some hard work removing the tarmac. My hardcore base is at least 20in deep, but is not remotely level, the peak (drive center) is about 4in above the correct level I have achieved at the ends of the drive.
I've tried to address this with a pick axe and have realised this is just not going to achieve results.
I think I could move forward through hiring a digger/skip - but is this unrealistic for a DIY approach ?
I have not had much luck finding a previous post which helps me dcide if this is the right solution or determine the skill level required.
Any advice would be really welcome.
Thanks