Posted: Fri Jul 07, 2006 5:24 pm
Hi All,
I'm midway through block paving our driveway and could really use some help. One end of my driveway butts up to our garage, the bottom end has a public footpath running along it at an angle, this is where my problem is, I intend to use an edge course (using normal blocks pavers) along the bottom of the driveway to butt up to the path, however there is a 15 inch difference between the length of the driveway to the path from one side to other, because of this path running along the bottom of the drive at an angle. I intended to cut each block, to take up the difference, keeping the main paving on the drive square but the 15inch difference is too much . Any help or advice would be greatly appreciated.
Thankyou All,
Stuart
I'm midway through block paving our driveway and could really use some help. One end of my driveway butts up to our garage, the bottom end has a public footpath running along it at an angle, this is where my problem is, I intend to use an edge course (using normal blocks pavers) along the bottom of the driveway to butt up to the path, however there is a 15 inch difference between the length of the driveway to the path from one side to other, because of this path running along the bottom of the drive at an angle. I intended to cut each block, to take up the difference, keeping the main paving on the drive square but the 15inch difference is too much . Any help or advice would be greatly appreciated.
Thankyou All,
Stuart