Page 1 of 1
Posted: Tue Jul 08, 2003 8:58 pm
by 99-1093880124
Where i was planning to pave the path falls to pavement.Only it is about 50mill higher.I want to edge the sides so how best to do it.Door step near path so cant increase height there.cheers
Posted: Wed Jul 09, 2003 2:01 pm
by 84-1093879891
Maybe it's the heat'n'humidity addling me brane, but I can't follow your description. The path you plan to lay is 50mm higher than the public footpath: is that correct? And you wish to use an edging kerb at the sides:correct?
I still can't see what's the problem! Try explaining it to me again.
Posted: Wed Jul 09, 2003 3:31 pm
by 99-1093880124
It is me i am good at explining on comps.The pavement is 50 mill higher.
Posted: Wed Jul 09, 2003 3:35 pm
by 99-1093880124
not good i mean
Posted: Wed Jul 09, 2003 5:19 pm
by 84-1093879891
So, you're looking to the interface between your new path and the public footpath, where there's a 50mm difference: is that it?
Posted: Wed Jul 09, 2003 6:58 pm
by 99-1093880124
Yes.
Posted: Fri Jul 11, 2003 12:14 pm
by 84-1093879891
What about using one of the kerb units? Would that work?
Posted: Sat Jul 12, 2003 4:48 pm
by 99-1093880124
I looked on the kerb page but arnt sure which would be best.At the moment it is like a angle fillet of concrete.but all the water sits round my gate posts.i may be better leaving the edge of and draining to the sides.would i have promlems with a water hydrent as it will be a little lower can you get small covers ?cheers.
Posted: Mon Jul 14, 2003 8:24 pm
by 84-1093879891
Can you send me a photo? I'm having difficulty visualising all of this.