Page 1 of 1
Posted: Mon May 19, 2003 2:20 pm
by Barry England
I can not decide if I should widen the entrance to my drive way when I have a block paved driveway laid. Current width if 1M70Cm which is a little tight when 1 car is already in the drive & we need to pass that car to park the 2nd. Is there a recommend / suggested width?
Thanks for the help.
Posted: Mon May 19, 2003 6:23 pm
by 84-1093879891
The minimum for a typical car is 2.1m, but that is quite tight, allowing only 150mm of clearance either side. Most driveways on new houses are laid to a minimum 2.4m width, and I would take that as a minimum opening width for comfort. However, if you're having work done, then you might as well make life as simple as possible and opt for a 3m opening, it possible, as that gives a good 600mm (2 feet in old money) of clearance on either side of a typical car.
Posted: Fri May 23, 2003 2:45 pm
by Barry England
Tony,
Many thanks for the advice. By the way, excellent site I will defiantly be using it again.
Have a good weekend!
Barry