Page 1 of 1

Posted: Tue Mar 19, 2002 10:25 am
by 66-1093879043
I have plans to lay a block paving drive , I currently have a tarmac drive about 40 years old, exploritary digging shows that it has a base made up of what appeare to be OLD BRICK CHIPPINGS,can this be left in place or should it be removed (the tarmac seems to be splitting from it leaving a clean base?

Posted: Tue Mar 19, 2002 11:30 am
by 84-1093879891
Hi Brian,

I should think it will be fine. If it's been carrying that bitmac drive for 40-odd years, then there's absolutely no point in ripping it out and replacing it with something new. You know it's not going to settle or move - not after all this time!

You may have to re-grade it to accomodate the different levels of the block paving. Most old bitmac drives are 75mm thick, whereas you need around 100mm to accomodate the bedding and the blocks, so scraping off the top 25mm or so and re-compacting is a likely task.

Also, if there are any serious voids in the old sub-base, it's well worth getting in a couple of tonnes or so of extra bedding sand (coarse grit sand), scattering that over the surface and wackering it in to fill any holes before placing the bedding layer.

Hope it goes well for you - keep us informed of how you're doing. :)