Page 1 of 1
Posted: Wed Aug 20, 2014 2:39 pm
by Bec@LondonStone
Hey folks, just wandered through the production factory and thought I'd show you this quick video I took of our profiling machine adding an edging detail to some granite steps. This is an amazing piece of kit and we haven't really tested it's full capabilities yet. We're chomping at the bit to get stuck into a really complex project so we can see what it can do, hopefully soon!
[IMG]http://i1376.photobucket.com/albums....MG]
Posted: Wed Aug 20, 2014 6:11 pm
by lutonlagerlout
myself and the gaffer saw it in action and it is a fab piece of kit
must save oodles of time
back on the lady question does anyone remember tarmac lady from america who used to be on here?
didnt she go into decking?
cheers LLL
Posted: Wed Aug 20, 2014 6:57 pm
by mickg
awesome bit of kit, can it profile curves too or just straight lines ?
Posted: Thu Aug 21, 2014 8:54 am
by Bec@LondonStone
I remember tarmac lady, she had lovely pink writing haha
Mickg, it can only do straight lines so anything curved is cut on the CNC and then profiled by hand.