Page 50 of 315
Posted: Sun Aug 07, 2011 2:14 pm
by lutonlagerlout
why didnt they text anyone eh?
been reading bill bryson's "at home" again
in the 18th century you only had a 1:2 chance of making 5 ,now thats scary
LLL
Posted: Sun Aug 07, 2011 3:13 pm
by joydivision
nice little tidy job that LLL.
Do BC not have you cut out the cavities on the existing house wall, or a vertical dpc?
JD
Posted: Sun Aug 07, 2011 5:37 pm
by Injured
Bob the setts are between 4 to 6 inches thick and laid on grit sand/cement bed. which is on 150mm compacted MOT Type 1. Bed is min 50mm thick.
If they were all the same thickness then they could be laid like block pavers on a compacted screeded bed of grit sand.
Posted: Sun Aug 07, 2011 5:39 pm
by GB_Groundworks
ive been reading the at home book its a good read
Posted: Sun Aug 07, 2011 6:19 pm
by lutonlagerlout
joydivision wrote:nice little tidy job that LLL.
Do BC not have you cut out the cavities on the existing house wall, or a vertical dpc?
JD
no mate
we had to do it in the 80s and early 90s but they stopped it now
apparently its only needed in exposed areas
cheers LLL
Posted: Sun Aug 07, 2011 7:51 pm
by joydivision
Really!
We stopped cutting the cavities out, but BC normaly want us top cut 40mm in and insert a vertical DPC.
Im in Manchester so most jobs are not in exposed locations either.
It does depend on which inspector turns up, but its usualy the case!
JD
Posted: Sun Aug 07, 2011 10:40 pm
by lutonlagerlout
if you look at rainfall maps for the uk i live in just about the driest areas and manchester is one of the wettest
but same as you we just do what they ask
I hate retro fitting cavity trays above an abutment,total waste of time
LLL
Posted: Mon Aug 08, 2011 5:31 pm
by joydivision
Dont mention retro fitted trays!
Fortunately only had to do one once!
Is it the NHBC that have now done away with trickle vents/weep holes? I think its them. Makes sense, if there is that much moisture in the cavity that it needs a hole to run out, then something is seriously wrong anyway!
JD
Posted: Mon Aug 08, 2011 7:26 pm
by lutonlagerlout
all council work has to have those retro fit trays
complete waste of time and weakens the walls,
the kids love the snowstorm when all the polystyrene insulation flies out!
plus they only allow £50 a metre supply and fit
whereas they allow around £250 to supply and fit a back inlet gully
spon has a lot to answer for!
LLL
Posted: Sat Aug 20, 2011 9:33 am
by Dave_L
Tidy work Tone!
Posted: Sun Aug 21, 2011 1:56 pm
by Pablo
Posted: Sun Aug 21, 2011 3:32 pm
by lutonlagerlout
well if you dont seal the vertical joint 99/100 it cracks and looks pants
that tobermore gear on the wall looks mint,never see such rich colours down this way
I have down a few tiered gardens and its a shame that it cos ts so much as the silly steep gardens are basically useless
thats a total transformation there pablo ,i bet they are over the moon
LLL
Posted: Tue Aug 23, 2011 10:11 pm
by Thepinkpavingco
Lovely work fellas like the use of the brick tongs Tony have two pairs myself couldn't be without them now. Keep up the good work